Character of Crusher Product Specification
Among the salient features of the non-choking con cave, we mentioned the character of the product. So far we have been dealing with crushers whose eccentric speeds are low enough to permit the material to fall, with each receding stroke of the active crushing member, the full distance allowed by the close- and open-side physical proportions of the crushing chamber, regardless of the shape of the concaves. In such crushers, the maximum one-way dimension of product particles is governed by the open-side discharge setting; therefore it is customary to predicate both product and capacity upon that setting. Actually, the sizing is done by the closing stroke of the crusher on the material in the zone just above the discharge opening; in other words, upon that material which will be discharged during the next opening stroke. It follows that the shape of the chamber immediately above the discharge opening must have some influence upon the product gradation, and we should expect that non-choking concaves, by virtue of the smaller angle they afford between head and con caves in. the discharge zone, would make a more uniform- and somewhat finer-product than straight concaves. This is true, and it is an important and favorable feature of these concaves, particularly so as applied to the production of commercial crushed stone.
One more word about the character of product. As the percentage of voids decreases in the crushing chamber, the amount of very fine material produced at each stroke is apt to increase, due to the crushing of particles against each other as they become more and more closely packed. Therefore the ratio-of-volume-reduction has a definite influence upon the amount of fines in the crusher product. This is especially true of friable materials. On such materials the substitution of non-choking concaves for those of the conventional type will usually result in marked decrease in the percentage of extremely fine material in the crusher product.
From the standpoint of power consumption, the best machine is the one tha't does the least amount of unnecessary work. A certain amount of nonproductive work is expended by any pressure-type crusher in "pushing around" material which is already small enough to pass the discharge opening but which is prevented from doing so because the particles are trapped in the surrounding body of material.
Anhydrite Composition, Crystallization & Structure BORNITE FLOTATION Froth Modifiers Collector Action Identifying Vanadium Minerals Diamond Drilling Standard Grindability Grate Ball Mills Identifying Cobalt Minerals Factors Influencing Crusher Performance Mining Glossary Feature of Gyratory Crusher Corundum Occurrence and Use Rocks and Minerals Technical Papers & Research Articals Subdivision of Channel in Vein Gallery
